Cleaning The Filter Cone - W'eau EV75 Manual De Usuario

CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging plug. Make sure the pool
vacuum is OFF
 Cleaning the filter cone
1. Place the pool vacuum on a stable surface.
2. Hold the pool vacuum and pry up the canister lever to the end to completely release
the side locks.
Detach the canister and turn the filter cone anticlockwise until the both triangular idents
are aligned. Take the filter cone out of the cleaner
CAUTION! Replace the damaged filter cone immediately before the next operation.
3. Clean out the debris and rinse the filter cone with water. If brushing is deemed
necessary, use only a soft brush to clean the filter cone gently and carefully.
4. Reverse the previous steps to re-assemble the filter cone. Turn the filter cone
clockwise until its side tab is secured inside the notch on both sides as shown. You
will hear a "click" sound.
.
16