Cleaning The Cartridge Filter; Maintenance & Storage - W'eau EV75 Manual De Usuario

5. Align and re-assemble the hood to the pool vacuum and make sure the lever is
completely pushed down to the hood. You will hear a "click" sound
 Clean the cartridge filter
Follow the instruction in "Cartridge filter setting" to detach cartridge filter.
Inspect everything for damage and wear. If you find any damages or tears, it's time to
replace the cartridge.
It is recommended to wash the cartridge filter with a water jet after each pool cleaning
cycle. Spray at an angle to get rid of the debris between the pleats of the cartridge filter.
Never use a pressure washer as it will damage the cartridges. If the cartridge is really
dirty, soak it in water with detergent for 2-3 hours, then rinse it with a water jet. If brushing
is deemed necessary, use only a soft brush to clean it carefully and gently to avoid any
damages.
MAINTENANCE & STORAGE
NOTE:
1. Be sure to clean and dry the areas around the charging port and charging pins after
every use to avoid the forming of stains (byproduct of a natural chemical reaction
between electric current and water). Otherwise, the stains can be removed by light
scrubbing with a cotton bud soaked with juice of lemon or vinegar.
2. Battery discharges on its own during storage. Make sure to charge the pool vacuum
to about 30% to 50% of the battery capacity before it is stored.
3. You must re-charge the battery at least once every three months when it is not in use.
 Unplug the external adaptor from socket and then unplug the adapter jack from the
charging plug.
 Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and
accessories with fresh water. DO NOT use detergent.
 Make sure to drain the water from the unit, handle and pole connector.
 Use a damp cloth to clean and dry the pool vacuum and its accessories.
 Store them in a well-ventilated area away from the sunlight, children, heat, ignition
sources, and pool chemicals. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher temperature may reduce the battery life during storage.
WARNING!
- Never attempt in any way to disassemble the pool vacuum.
- Under no circumstances should you attempt to disassemble the pool
vacuum and replace the impeller, motor and battery by yourself.
CAUTION!
 Excessive heat can damage the battery and reduce its lifespan as a result.
Consult your dealer regarding battery replacement if the following happens:
- Battery does not charge fully.
- Battery operation time is noticeably reduced. Observe and record the run times of the
first few operations (on a full charge). Use these run times as a reference point for
comparison with run times in the future.
 The battery must be removed from the pool vacuum before it is scrapped.
17