Oil Alert® System; Servicing Your Engine; The Importance Of Maintenance; Maintenance Safety - Honda GC160 Manual Del Propietário

Ocultar thumbs Ver también para GC160:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TYPE 3: FIXED THROTTLE / ENGINE STOP SWITCH /
MANUAL CHOKE
Starting The Engine
1. Pull the choke rod to the
CLOSED position (cold
engine).
2. Move the engine stop switch
to the ON position.
Some engine applications
use a remote-mounted
ignition switch rather than
the engine-mounted engine
stop switch shown here.
3. Pull the starter grip lightly until
resistance is felt, then pull
briskly.
NOTICE
Do not allow the starter grip to
snap back against the engine.
Return it gently to prevent
damage to the starter.
4. If the choke rod was pulled to
the CLOSED position to start
the engine, push it to the OPEN
position as soon as the engine
warms up enough to run
smoothly.
5. The engine speed is preset on this type.
Stopping The Engine
Move the engine stop switch to the OFF position.
®
OIL ALERT
SYSTEM
The Oil Alert system is designed to prevent engine damage caused by
an insufficient amount of oil in the crankcase. Before the oil level in
the crankcase can fall below a safe limit, the Oil Alert system will
automatically stop the engine [the throttle lever (ignition switch lever)
will remain in a run position].
If the engine stops and will not restart, check the engine oil level
(page 6) before troubleshooting in other areas.
4
CHOKE ROD
OPEN
CLOSED
ON
OFF
ENGINE
STOP
SWITCH
STARTER GRIP

SERVICING YOUR ENGINE

THE IMPORTANCE OF MAINTENANCE

Good maintenance is essential for safe, economical and trouble-free
operation. It will also help reduce pollution.
B WARNING
Improper maintenance, or failure to correct a problem
before operation, can cause a malfunction in which you
can be seriously hurt or killed.
Always follow the inspection and maintenance
recommendations and schedules in this owner's manual.
To help you properly care for your engine, the following pages include
a maintenance schedule, routine inspection procedures, and simple
maintenance procedures using basic hand tools. Other service tasks
that are more difficult, or require special tools, are best handled by
professionals and are normally performed by a Honda technician or
other qualified mechanic.
The maintenance schedule applies to normal operating conditions. If
you operate your engine under severe conditions, such as sustained
high-load or high-temperature operation, or use in unusually wet or
dusty conditions, consult your servicing dealer for recommendations
applicable to your individual needs and use.
Remember that an authorized Honda servicing dealer knows your
engine best and is fully equipped to maintain and repair it.
To ensure the best quality and reliability, use only new Honda
Genuine parts or their equivalents for repair and replacement.
Maintenance, replacement, or repair of the emission control
devices and systems may be performed by any engine repair
establishment or individual, using parts that are "certified" to
EPA standards.

MAINTENANCE SAFETY

Some of the most important safety precautions follow. However, we
cannot warn you of every conceivable hazard that can arise in
performing maintenance. Only you can decide whether or not you
should perform a given task.
B WARNING
Failure to properly follow maintenance instructions and
precautions can cause you to be seriously hurt or killed.
Always follow the procedures and precautions in this
owner's manual.
Safety Precautions
• Make sure the engine is off before you begin any maintenance or
repairs. This will eliminate several potential hazards:
– Carbon monoxide poisoning from engine exhaust.
Be sure there is adequate ventilation whenever you operate
the engine.
– Burns from hot parts.
Let the engine and exhaust system cool before touching.
– Injury from moving parts.
Do not run the engine unless instructed to do so.
• Read the instructions before you begin, and make sure you have
the tools and skills required.
• To reduce the possibility of fire or explosion, be careful when
working around gasoline. Use only a nonflammable solvent, not
gasoline, to clean parts. Keep cigarettes, sparks and flames away
from all fuel related parts.
ENGLISH

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gc190

Tabla de contenido