Kreg Jig K5 Manual Del Usuario página 9

All manuals and user guides at all-guides.com
Pocket-Hole Placement
8
In addition to the proper Kreg Jig settings, spacing pocket holes evenly across the workpiece is an
®
important part of getting a strong joint. The Kreg Jig features a three-hole drill guide that allows you
®
do this in a variety of workpiece widths without the need to reposition the workpiece after drilling each
hole. Use the guide below to determine how to position your workpiece for drilling pocket holes.
1" to 2" Wide Material 2" to 3" Wide Material 3" to 4" Wide Material
(25mm to 51mm Wide Material) (51mm to 76mm Wide Material) (76mm to 102mm Wide Material)
Use B and C guides Use A and B guides Use A and C guides
For wide parts such as panels, we recommend placing the first pocket hole 2" (51mm) from the panel
edge and every 6" (152mm) to 8" (203mm) on center after that. When drilling panels, you can use any
drill guide hole.
Drilling Pocket Holes
Before turning on the drill, slide the bit into the drill guide until the tip of the bit touches the
workpiece. Withdraw the bit about ¼" (6mm). Turn on the drill, make sure it is running at
full speed, and feed the bit into the workpiece. Always run variable-speed or multi-speed
drills at the fastest speed. A shop vacuum connected to the vacuum port quickly removes
the wood chips and the hole can be drilled in one motion. When not using a shop vacuum,
remove the vacuum port, and while drilling the pocket hole, partially withdraw the bit
several times to clear the chips. Stop drilling when the stop collar contacts the drill guide.
Wait until the drill stops rotating to withdraw the bit from the drill guide.
Joining parts
With the pocket holes drilled, position and clamp your parts. Small flat assemblies can be
aligned by clamping them to a flat surface. When using a Kreg clamp to clamp large flat
assemblies off the edge of your work surface, position the large clamp pad on the side of
the joint opposite the pocket holes. Align the corners of case assemblies, such as a cabinet
or bookshelf, using bar clamps or a Kreg right-angle clamp. (See Optional Accessories.)
With your assembly securely clamped, drive the pocket screws using a variable-speed
drill/driver and the included 6" (152mm) driver bit. For drills with a clutch, adjust it to fully
seat the screws without over-driving them.