Installation Procedure; Preparing The Cooktop - Bosch NGM5458UC Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation with horizontal panel
If there is no oven beneath the cooktop, install a horizontal
panel. To allow access to the power supply connection
and regulator maintain a minimum clearance of
⅜" (10 mm) from the edges of the panel (F).
IMPORTANT: Complete the installation of the cooktop be-
fore installing the horizontal panel.
Installation above a drawer
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
min. 0" (0 mm)
E
2⅜" (60)
F
min. ⅜" (10 mm)
Installation above a cabinet door
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
min. 0" (0 mm)
E
2⅜" (60)
F
min. ⅜" (10 mm)
G
min. 1" (25)
4 Installation procedure

Installation procedure

Follow these instructions to install the cooktop into the
Installation procedure
countertop.
CAUTION
Sharp edges.
Use protective gloves when installing the appliance.
4.1 Preparing the cooktop
Place the cooktop face down on a soft and stable sur-
1.
face. Use the foam sheet from the packaging to protect
surfaces from scratching.
Apply the included foam sealing tape around the edges
2.
of the underside of the appliance along the rough-in box
flange.
Insert the two fixing clips into the slots at the rear side of
3.
the cooktop.
Installation procedure en-us
9

Publicidad

Tabla de contenido
loading

Tabla de contenido