Batteries Installation - ITS EK HDT2 Manual

EN
TV/RADIO : Switch between Radio Channels and TV Channels
RECALL : Goes back to previous viewed channel
LEARNING FUNCTION BUTTONS:
•The remote control has 4 programmable buttons for controlling the TV: TV Power,
Vol +, Vol-, TV/AV.
•Long press the SET button for 3 seconds, the red LED will be from low light to brigh-
ter light,release the SET button.
•Place the learning and the original remote control from the TV opposite to each
other at a distance of 3-5 cm.
•Press and release the learning remote control button you want to program,the
red LED will light blinking.
•Press the button of the original remote control, the LED should blink 2 times and
light constantly, release the button.
•When learning is completed, press the SET button, the LED
will turn off.

BATTERIES INSTALLATION

1. Open the battery compartment cover.
2. Insert 2x AAA batteries with correct pola-
rization.3. Close the battery compartment
cover.
Notes:
Do not mix the batteries.
Remove the batteries if the remote control is not going to be used for an extended
period of time.
Do not place the remote control under the direct sunlight or near sources of
excessive heat.
Point the remote control to the receiver, no more than 8 meters from the remote
control. Sensor.