Troubleshooting - Hoover Quick & Light FH50035 Manual Del Propietário

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug cleaner before servicing.
probleM possible Cause
1. Power cord not firmly plugged
Cleaner won't
into outlet.
run
2. Blown fuse or tripped breaker.
3. Needs service.
1. Dirty Water Tank Door not
Cleaner won't
installed.
pick-up or low
2. Dirty Water Tank is not installed
suction
correctly.
3. Dirty Water Tank is full.
4. Dirty water passage clogged.
5. Foam filter is dirty.
1. Dirty Water Tank is full.
Water escap-
2. Dirty Water tank is not installed
ing from
correctly.
Cleaner
3. Clean Water Solution Tank not
installed properly.
1. Clean Water Solution Tank not
Cleaner won't
installed properly.
dispense
2. Needs service.
1. Hose is clogged.
Cleaner
attachments
2. Hose inlet clogged.
won't pick up
3. Dirty Water Tank is full.
1. Water supply hose not
Cleaner
connected properly.
attachments
won't spray
1. The float in the Dirty Water Tank
Motor noise
has been activated.
becomes
high-pitched
All manuals and user guides at all-guides.com

4. troubleshootinG

WARNING
!
13
!
possible solution
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Take to service center. To find nearest
location, visit our website at www.hoover.com
or call 1-800-944-9200.
1. Insert Dirty Water Tank Door - Pg. 9.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 10.
3. Empty Dirty Water Tank - Pg. 10.
4. Clean Dirty Water Tank - Pg. 10.
5. Clean filter. Review Emptying & Cleaning the
Dirty Water Tank - Pg. 10.
1. Emptying Dirty Water Tank - Pg. 10.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 11.
3. Review Clean Water Solution Tank
Installation - Pg. 8.
1. Review Clean Water Solution Tank
Installation - Pg. 8.
2. Take to service center. To find nearest
location, visit our website at www.hoover.com
or call 1-800-944-9200.
1. Remove hose and tools; remove obstruction
- Pg. 9.
2. Remove hose and clean inlet - Pg. 9.
3. Empty Dirty Water Tank - Pg. 10.
1. Connect trigger water supply connector and
base water supply connector - Pg. 9.
1. Review Emptying & Cleaning the Dirty Water
Tank - Pg. 10.