Carpet Cleaning; Above Floor Cleaning/Attachments - Hoover Quick & Light FH50035 Manual Del Propietário

Carpet CleaninG

2.7 Plug cord into electrical outlet. Step on handle
release pedal, to put unit in cleaning position.
2.8 Turn power switch to the "ON" position.
IMPORTANT
Never leave unit unattended with power on.
Turn OFF when emptying and filling tank. Do
NOT oversaturate the carpet.
2.9 While depressing solution spray trigger, slowly
push unit forward. Release trigger and pull unit
backward in the same path to remove dirty water
and solution from carpet. (For heavily soiled areas,
repeat if necessary).
IMPORTANT
If the sound of the motor changes to a high
pitch, this indicates the dirty water tank is full
and must be emptied..
note: For best cleaning results use a steady,
forward and backward motion. Cleaning should be
done at half the speed of dry vacuuming. For
heavily soiled areas, repeat if necessary.
above floor CleaninG/
attaChMents
2.10 Put cleaner in its upright position. Connect the
upholstery attachment to the trigger adaptor.
2.11 Remove the dirty water tank door.
2.12 Insert the hose adaptor into the dirty water
tank.
2.13 Connect the base water supply connector into
the fitting on the lower left side of handle facing
cleaner (A).
attachment usage
2.14 Turn power switch on. While depressing
solution spray trigger, push attachment forward.
Release trigger and pull attachment backward in
the same path to remove dirty water and solution
from upholstery. (For heavily soiled areas, repeat if
necessary.)
IMPORTANT
Do NOT oversaturate the upholstery.
FOR BEST CLEANING RESULTS USE STEADY, MODERATE, FORWARD
AND BACKWARD MOTION. Make sure upholstery is dry before use.
If the hose attachment door is not replaced, there will be no suction through
the nozzle and the unit will not operate properly.
All manuals and user guides at all-guides.com
9
2.7
2.9
2.10
2.12
2.8
Power
ON/OFF
Switch
2.11
2.13
a
2.14