ECOVACS ROBOTICS DEEBOT M81 Manual De Instrucciones página 12

3. Operating and Programming
5
Charge DEEBOT
Remove the Advanced Wet/Dry Reservoir
before charging DEEBOT.
Place DEEBOT on the Charging Dock
making sure the Charging Contacts on
DEEBOT and the Charging Dock Pins make
a connection.
Charge DEEBOT for at least 4 hours before
the first use.
button blinks when DEEBOT is charging and stops glowing when DEEBOT is fully charged.
*
Remove the robot's battery if the robot will not be used for a long time. In case of battery
*
leakage, please remove the battery and wipe the battery slot clean while wearing protective
gloves, and dispose of it according to local laws and regulations.
If the robot's battery is fully discharged or not used for a long time, its capacity may decrease
*
and need to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after charging
*
for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT uses a long life battery and does not require frequent replacement. To replace the
*
battery, contact Customer Service or follow the below instructions:
a. Press and hold the
Remove the Battery Pack.
b. Insert new Battery Pack into battery slot and press until it clicks into place.
6
Attach a Cleaning Cloth, if Desired
To use DEEBOT's Optional Advanced Mopping System, attach the provided Cleaning Cloth.
* When using the optional mopping feature, fold area rug edges under themselves so DEEBOT will
avoid the rug.
* Please see section 3.5 Optional Advanced Wet/Dry Mopping System for complete instructions.
10
EN
button on the robot until it stops glowing to power OFF the robot.