Switching Off; Optional Accessories; Care And Maintenance - Hilti SPN 6­-A22 Manual De Instrucciones

6.3 Cutting with template
Option: SPN­CN
The requirements for cutting with a template are as follows:
• The template must be 5 ­ 7 mm thick.
• The contour of the template must be 2.5 mm distant from the contour of the cut.
• Note that the minimum radius is 4 mm. Accordingly, the minimum radius of the template is 6.5 mm.
• Guide the nibbler in such a way that the outside edge of the punch guide is always in contact with the
template.
6.4

Switching off

▶ Press the rear section of the on/off switch.
➥ The on/off switch jumps into the off position and the motor stops.
7

Optional accessories

7.1 Installing the swarf bag
Option: SPN­CN
A swarf bag can be installed to catch the pieces of swarf produced by the cutting operation so that they
cannot scatter.
1. Squeeze the two ends of the spring in the swarf bag together.
2. Hook the spring round the bottom end of the die and release the ends of the spring.
3. Check that the spring and the swarf bag are correctly seated and secure.
8

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove any dirt that may be adhering to parts.
• Remove the dust filter and clean it and the air vents carefully, using a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the lithium­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
*2253587*
6
7
2253587 English 9