Assembling / Deassembling; Operation And Handling; Before Initial Use; Security Switch - CASO DESIGN AF 600 XL Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 88
14.6

Assembling / Deassembling

The cover over the frying basket release
button protects against accidentally
unlocking it. Flip the cover open, hold the
button down and remove the frying basket
from the container by pulling the handle
upwards.
Assembling: Place the inner frying basket
into the pot until it latches. Close the cover
above the button for release of frying basket.
► The handle is attached to the inner frying basket, not to the outer container.
► Only press the basket release button when the container with the basket is standing
flat on a level, heat-resistant surface.
► Never press the release button while carrying the container with the frying basket,
otherwise the container could fall.
► Remove the frying basket from the container only for taking out the cooked food or for
cleaning.

15 Operation and Handling

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
15.1

Before initial use

 Thoroughly clean the basket and the pot with hot water, some washing-up liquid and a
non-abrasive sponge. The inner frying basket can also be washed in the dishwasher.
 Wipe the inside and outside of the appliance with a moist cloth.
 Dry the parts thoroughly after you have been flushed and put the unit back together
 For further cleaning instructions, please refer to the chapter " Cleaning and
Maintenance".
15.2

Security switch

This appliance is equipped with a secure switch. When pulling the pot out of the fryer
during it's working, the fryer will stop heating and timer on hold automatic until the pot is
put back.
► It's better to pull out the pot not longer than 30s, to make sure the stable temperature
inside the pot to have better result.
15.3

Overheating protection

The device has an overheating protection. In case of too high temperature inside the
device close to electronic components the device will switch off automatically. Pull the plug
and let the device cool down at leat for half an hour.
Please note
Please note
40

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3180

Tabla de contenido