GIESSE RACK MAX 650 Manual De Uso E Instalación página 59

This partly completed machine must not be put into service until the final machinery into which it is to be
incorporated has been declared in conformity, where appropriate, with the provisions of Machinery Directive
2006/42/EC (the CE mark required under this same directive is consequently not affixed).
This Declaration of incorporation is issued under the sole responsibility of the manufacturer.
The manufacturer undertakes, in response to a reasoned request by the national authorities, to transmit
relevant information on the partly completed machinery; such an undertaking includes the methods of
transmission and shall be without prejudice to intellectual property rights owned by the manufacturer of the
partly completed machinery.
Budrio, dated 29/04/2021
The officer
Peter Santo,
Legal Representative, GIESSE S.p.A
59