Fisher-Price 79152 Manual Del Usuario página 4

Cradle Use
Seat
• Hold the base with one hand.
• Rotate the seat counter-clockwise until it snaps into position.
• The Cradle Rocker Seat is ready for cradle use.
Rocker Seat Use
• Hold the base with one hand.
• Rotate the seat clockwise until it snaps into position.
• The Cradle Rocker Seat is ready for rocker seat use.
©1996 Fisher-Price, Inc., East Aurora, New York 14052
Feeding Seat Use
Base
Base
• Make sure the Cradle Rocker Seat is in the rocker position.
• Lift the rear of the base to locate the support.
• Pull the support down from the underside of the base until it
snaps into position, as shown.
• Lower the base.
• Push down on the base to be sure it is secure.
• To use the Cradle Rocker Seat as a cradle or rocker seat,
push the support up into the underside of the base.
Care
The seat pad and restraint shield pad are machine washable.
Machine wash them in cold water on the gentle cycle. Do not
use bleach.Tumble dry on low heat and remove promptly.
The plastic seat and waist belts may be wiped clean using a
mild cleaning solution and a damp cloth. Rinse with clean
water to remove soap residue.
"T" End
Fastener Straps
To remove the restraint shield and pad:
• Lift the foot of the Cradle Rocker Seat.
• Remove the fastener straps from the fasteners.
• Fold the "T" end of the restraint shield belt flat and push it up
through the slot in the bottom of the seat.
• Pull the restraint shield belt through the slot in the pad.
• Lift the foot of the pad and pull the ends of the waist belts
through the slots in the pad.
• Remove the pad from the seat.
Please Note: Do not use the Cradle Rocker Seat without the
pad and the restraint system. Review the instructions in the
"Assembly" section to re-assemble this product.
4
79152, 79251, 79252, 79253, 79273, 79274, 79375, 79377 2 79152-0920
Support
Slot