Kit Assembly - Metra 99-7526B Instrucciones De Instalación

1. Attach the (4) panel clips provided onto
the radio trim panel (a). (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
Note: The wiring harness and antenna
connector are located in the passenger
kick panel, except for the 2014 i-Sport.

KIT ASSEMBLY

(Figure A)
(Figure B)
5. Insert the radio into the sub-dash and
secure it using the (2) Phillips screws
provided. New screw holes will have to
be drilled into the sub-dash. Either drive
the screws in, or pre-drill the holes with
a 1/8" drill bit.
6. Attach radio trim panel (a) to the
assembly.
7. Starting from the bottom, attach radio
trim panel (b) to the assembly.
8. Reassemble the dash in reverse order of
disassembly to complete the installation.
3
REV. 4/18/2022 INST99-7526B