Installation; Choosing An Appropriate Installation Location; Removing The Packaging And Inspection - Hisense WFMC6010E Manual De Funcionamiento

4 INSTALLATION

4.1 Choosing an appropriate installation location

Minimum housing dimensions:
Width: 600 mm
Height: 850 mm
Depth: refer to the
Do not place the product on a floor without sufficient capacity to carry the load.
Do not install the product in places where there is the risk of freezing.
Move the appliance without lifting it by the worktop.
Note:
1. Preparation of the location and electrical, tap water and waste water
installations at the place of installation is under customer's responsibility. Make
sure that the installation and electrical connections of the product are performed
by competent persons.
2. Make sure that the water inlet and drain hoses as well as the power cable are
not folded, pinched or crushed while pushing the product into its place after
installation or cleaning procedures.
3. The appliance must be installed on a solid and level floor surface (if
necessary use a spirit level). If the appliance is to be installed on a wooden
floor, distribute the weight by placing it on a 60 x 60 cm sheet of plywood at
least 3 cm in thickness and secure it to the floor. If the floor is uneven, adjust
the 4 leveling feet as required; do not insert pieces of wood etc. under the feet.
4. Never place the product on a carpet-covered floor.
5. Do not lean the product on furniture, keep a distance between them.
6. Do not place the product on any platform.
7. Manufacturer shall not be held liable for damages that may arise from
procedures carried out by unauthorised persons.

4.2 Removing the packaging and inspection

There is risk of getting injured, two or more people are needed for
removing the packaging.
After unpacking, ensure that the washing machine is undamaged. If in doubt, do
not use the washing machine. Contact After-Sales Service or your local retailer
Check that the accessories and supplied parts are all present.
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of
children, as they are potentially dangerous.
6
Specification