Sime ESTELLE B4 INOX ERP BE Manual Del Usuario página 52

3.7.4 Setting the pump operating mode
LED display
1
2
3
4
5
6
7
8
9
• Pressing the button for the 9th time returns to
the basic setting (constant speed / characteristic
curve III).
3.7.5 Possible pump faults, causes and possible solutions
Colour of LED Possible fault
Turbine operation
Idle operation
Flashing
red-green
Under/overvoltage
Flashing
Excessive temperature
red
Steady "Permanent lockout"
red
LED Off
52
Control mode Pump curve
Constant speed II
I
Constant speed
Variable di erential III
pressure
p-v
II
Variable di erential
pressure
p-v
Variable di erential I
pressure
p-v
III
Constant di erential
pressure
p-c
Constant di erential II
pressure
p-c
I
Constant di erential
pressure
p-c
Constant speed III
Cause
The hydraulic system of the pump is pow-
ered, but the pump has no mains voltage
Air in the pump
The motor runs with difficulty. The number
Overload of revolutions is lower compared to normal
operation
Supply voltage too low/high
Excessive temperature inside the pump
Short circuit Motor current too high
Rotor blocked
stop
Circuit board and/or motor failure
Electrical power failure
Stopped Faulty LED
Faulty circuit board
Variable Recommended for two-pipe heating systems with radi-
di erential ators to reduce the ow noise at thermostatic valves.
pressure
p-v (I, II, III)
The pump reduces the delivery head to half in the case of
H/m
decreasing volume ow in the pipe network.
III
II Electrical energy saving by adjusting the delivery head to
I
the volume ow requirement and lower ow rates.
There are three pre-de ned pump curves (I, II, III) to
choose from.
Q/m³/ h
Constant Recommended for under oor heating for large-sized
di erential pipes or all applications with out a variable pipe network
pressure curve (e.g. storage charge pumps), as well as single-pipe
p-c (I, II, III) heating systems with radiators.
The control keeps the set delivery head constant irre-
H/m
III
spective of the pumped volume ow.
II
There are three pre-de ned pump curves (I, II, III) to
choose from.
I
Q/m³/ h
Constant Recommended for systems with xed system resistance
speed (I, II, III) requiring a constant volume ow.
The pump runs in three prescribed xed speed
H/m
III
stages (I, II, III).
II
NOTICE
I
Factory setting:
Constant speed, pump curve III
Q/m³/ h
Possible solution
- Check the mains voltage
- Check that there are no leaks in the
system
- Check the mains voltage
- Check the system flow rate/pressure
- Check the characteristics of the water
in the system; remove debris from the
system
- Check the mains voltage
- Check the water temperature level in re-
lation to that of the ambient temperature
- Check the mains voltage
- Check the environmental operating condi-
tions
- Check the mains voltage
- Restart manually
- REPLACE THE PUMP
- REPLACE THE PUMP
- Check the connection to the power supply
- Check to see if the pump can work
- REPLACE THE PUMP