Standard Accessories; Safety Instructions - Ega Master EGATRONIK 51719 Manual De Instrucciones

Caution: Please read the safety instructions carefully before use.
Open the package and check the below items, if any is missing or damaged, please contact
your supplier immediately:
User manual
Test leads
Cloth bag
WARNING!
To ensure safe operation and service of the tester, follow these instructions. Failure to
observe these warnings can result in severe injury or death.
The meter is designed according to EN61010-1, 61010-2-032/033 and electromagnetic
radiation protection EN61326-1 safety standards, and conforms to double insulation, CAT II
600V, CAT III 300V and pollution grade II. In case the meter is not used properly as instructions,
the protection provided may be weakened or lost.
- Before each use verify tester operation by measuring a known voltage.
- Before use, please check if there is any item which is damaged or behaving abnormally. If
any abnormal item (such as bare test lead, damaged meter casing, broken LCD, etc.) is found,
or if the meter is considered to be malfunctioning, please do not use the meter.
- Do not use the meter if the rear cover or the battery cover is not covered up, or it will pose
a shock hazard!
- Keep fingers behind the finger guards and away from the metal probe contacts when
making measurements.
- The function switch should be placed in the correct position before measurement. It is
forbidden to change the position during measurement to avoid damage to the meter!
- Do not apply voltage over 600V between any meter terminal and earth ground to prevent
electric shock or damage to the meter. Use caution when working with voltages above AC
30Vr.m.s, 42Vpeak or DC 60V. Such voltages pose a shock hazard.
- Never input voltage or current which exceeds the specified limit. Maximum range should
be selected if measured value is unknown. Before measuring resistance, diode and continuity,
please disconnect all power and fully discharge all capacitors to avoid inaccuracy.
- When the "
ensure measurement accuracy. Batteries should be removed If the meter is long-term idle.
- Do not change the internal circuit of the meter to avoid damage to the meter and user!
- Do not expose the meter in high temperature/humidity, flammable, explosive or intense
magnetic environments.
- Clean the meter casing with a soft cloth and mild detergent. Do not use abrasives or
solvents!.

STANDARD ACCESSORIES

1 pc
1 pair
1 pc

SAFETY INSTRUCTIONS

" symbol appears on the LCD, please replace the batteries in time to
15