Sanus BMT1 Manual De Instrucciones página 23

STEP 2D
Min. 16 in.
(406 mm)
CAUTION
: Avoid potential personal
injuries and property damage!
● Studs must be at least 2 x 4 / 25 ga.
● If back side of wall is unfinished, drywall
must be installed to a minimum of one stud
left and right of the stud(s) being used to
install the mount.
● Drywall must be a minimum of 1/2 in. (13 mm)
thick on each side of the studs, and a
minimum clearance of 1 7/8 in. (48 mm)
behind the wall is required.
● This product must be centered on the studs.
● Stud type and structural strength
must conform to the North American
Specification for the Design of Cold-Formed
Steel Structural Members
[362 S 125 18, C-Shape, S - Stud Section].
● Drywall must be secured to studs with
screws 12 in. (304.8 mm) on center.
Steel Stud Option (Double and Single Stud Install)
Steel Stud Anchor Kit [NOT INCLUDED]
Contact Customer Service at
1-800-359-5520 to have this
additional hardware shipped
directly to you.
Anchor
S1 x4
1
1. Locate the studs using a stud finder.
2. Find the edges of the studs using an awl or small drill bit.
3. Mark the centers of the studs with a pencil.
1/4-20 Snap Toggle BB
2
Screw
1/4-20 x 1.75
S2 x4
3
Washer
.734 x .312 x .065 in.
S3 x4
23