Error Codes; Care And Cleaning - Oster CKSTAF90D Manual De Instrucciones

Problem
Screen not responding
Error code on display
E1
E2
E3
E4
Always unplug your Air Fryer and allow it to cool completely before cleaning it. NEVER immerse the
MAIN body, power cord or plug in water or any other liquid. Never use harsh abrasive cleaners or
cleaning materials.
• Carefully wipe any oil spatter from the air frier roof with kitchen paper or a slightly damp cloth. Wipe over
the outer body with a clean, slightly damp cloth and dry.
• Wash the removable cooking basket, cooking tray and handle with warm soapy water using a cloth,
sponge or non-abrasive brush. Dry completely before use or storage.
• To avoid grease build up on the roof and fan of the unit, it is recommended to do a deep cleaning once a
month (refer to deep cleaning instructions)
Deep cleaning
1. In a heat resistant bowl, prepare a mix by mixing 1 cup of water, 2 tbsp of vinegar and the juice of half a
lemon or lime
2. Carefully place inside the air fryer and run at 200ºC for 30 minutes
3. Allow enough time for air fryer to cool down before handling, use extra caution to verify the heating ele-
ment and the roof of the air fryer are cool to handle.
4. Flip the air fryer upside down. Using a damp towel proceed to clean the surroundings of the heating
element, fan and the whole air fryer roof surface, if necessary you can also use a small soft nylon brush
(like a tooth brush) to scrub the surface and remove any baked grease.
5. Do NOT use water or a wet sponge to clean this area as this could cause permanent damage to the
device, only use a dry towel or slightly damp cloth.
CKSTAF90D_22SEM3.indd 11 CKSTAF90D_22SEM3.indd 11
Potential Cause
--
Component failure

Error Codes

Contact Oster Customer Service
Unplug unit, wait for unit to cool down, plug back in and press start
button. If unit does not function, call Oster Customer Service
Call Oster Customer Service
Call Oster Customer Service

Care And Cleaning

English - 11
Solution
Unplug unit, wait 10 secs and
plug back in
Unplug unit, wait 10 secs and
plug back in, if unit does not work
contact Oster customer service
and provide error code.
2022/1/20 9:26 AM 2022/1/20 9:26 AM