Performing Resistance Measurement And Continuity Test - Keysight U1211A Guía Del Usuario Y Servicios

2 Making Measurements

Performing Resistance Measurement and Continuity Test

Disconnect circuit power and discharge all high-voltage capacitors before
CAUTION
measuring resistance or conductance, or testing circuit continuity, to avoid
damaging the clamp meter or the device under test.
Steps
1 Set the rotary switch to Ω.
2 Connect the red and black test leads to input terminals Ω (red) and COM
3 Probe the test points (by shunting the resistor) and read the display.
4 To perform continuity test, press Shift once (see
40
(Figure 2-3 on page 41):
(black) respectively.
buzzer will sound when the resistance is below 10.0 Ω.
Keysight U1211A, U1212A, and U1213A User's and Service Guide
Figure 2-4 on page 42). The