Setting Data Hold/Refresh Hold Mode - Keysight U1211A Guía Del Usuario Y Servicios

4 Changing the Default Settings

Setting Data Hold/Refresh Hold mode

To enable the data hold mode (manual trigger), set this parameter to OFF.
To enable the refresh hold mode (automatic trigger), set the variation count within
the range of 100 to 1000 in a step of 100. Once the variation of the measured
value exceeds this preset variation count, the refresh hold mode will be ready to
trigger and update a new value.
Figure 4-3
70
Press
Press or to
edit the value at a
step of 100
Setting the data hold or refresh hold mode
Keysight U1211A, U1212A, and U1213A User's and Service Guide
Press
Press
Press