2) Dissolve 2 tablespoons (about 30 grams) of citric acid (available in drug-
stores or chemists) into the water.
3) Replace the water tank 1 into the appliance.
4) Switch the appliance on with the on/off switch 3. The rotary switch 5 must
be in the position "
5) Insert the sieve carrier w, without either of the espresso sieves 0/q, into the
appliance and place a cup under the sieve carrier w. As soon as the green
heating-up control lamp 4 glows, turn the rotary switch 5 to the position "
6) Let about 2 cups (coff ee cups) of water pass through and then stop the process.
7) Hold a container under the milk frother z.
8) Place the rotary switch 5 at the position " " and wait until the green heat-
ing-up control lamp 4 glows. Slowly turn the steam control knob 2 to the
position "+ ". Allow the appliance to create steam for about 2 minutes.
9) After 2 minutes close the steam control knob 2, set the rotary switch 5 to the
position "
10) Let the scaling agent take eff ect for about 15 minutes.
11) Repeat the steps 4 - 10 three times.
12) Then place the rotary switch 5 at the position "
through until the water tank 1 is empty.
13) Rinse the water tank 1 with clean water and then fi ll it with clean water up
to the MAX marking.
14) Turn the rotary switch 5 to the position "
up control lamp 4 glows.
15) Allow the water to run through.
16) Repeat the steps 13 - 15 three times.
17) Fill the water tank 1 with water once again.
18) Turn the rotary switch 5 to the position " ".
19) Hold a container under the milk frother z and slowly rotate the steam control
knob 2 to the position "+" as soon as the green heating-up control lamp 4
glows.
20) After about 1 minute close the steam control knob 2, set the rotary switch 5
to the position "
NOTICE
►
After 3 minutes the appliance will switch itself off automatically.
SEM 1100 A2
". The steam control knob 2 is closed.
" and switch the appliance off .
" and switch the appliance off .
" and let the solution fl ow
" as soon as the green heating-
GB
MT
".
37