Symbols; Safety Pictograms; Manufacturer Identification; About Technical Support And Maintenance - KRAFTWERK 505.003.170 Manual De Uso Y Mantenimiento

2.1.2 Symboles
NOTE
It provides important information to be read
paying attention for a proper and correct use of
the equipment.
DANGER
It indicates a situation that can result in injuries,
even fatalities, or serious damage to health.
ATTENTION
It indicates a situation that could cause, even
indirectly, damage to people, things and the
environment with economic consequences.
WARINING
It indicates that you need to carefully follow
the directions. Failure to comply with the
report may cause malfunctions or dangerous
conditions or damage.

SAFETY PICTOGRAMS

Warning signs (caution, caution check)
Direct
vision
potentially
dangerous
Stumbling danger
Prohibition signs (Dangerous, Hazardous behaviour,
Interruption Devices, Emergency)
Prohibition of
extinguish fires

3. MANUFACTURER IDENTIFICATION

The label on the side of the equipment contains all the
identifying data.
The figure below shows the format of the label.
Mod. = Equipment model
Art. = Equipment identification code
beam
is
using water to
Year = Production year
Serial no. = Manufacturing serial number
Weight: = Equipment weight
It is absolutely forbidden to remove or tamper
with such a license plate. If this license plate is
accidentally
manufacturer.

3.1 About technical support and maintenance

For communications or requests for information or spare
parts, send the form "spareparts list, misfunctioning issue,
warning issues" in Annex 1.
To maintain warranty coverage, Customer
must follow manual instructions. Otherwise,
product problems or malfunctions in the
operation of the equipment will not be covered by warranty
terms (in this regard, read carefully the warranty attached to
the manual).
In order to adapt the equipment to technological
progress and specific production requirements,
the manufacturer may decide, without any
warning, to make changes on it without requiring
the obligation to update production and previous manuals. In
addition, if the illustrations in this manual differ slightly from
the equipment in your possession, the safety and indications
of operation of the same are always guaranteed.

4. TECHNICAL DATA SHEET

4.1 Basic configuration

Mirror visor for alignment (reflection mode)
Test set up and measurement sizes
Set up orientation test
VISUAL CHECK - UP and
DOWN
VISUAL CHECK - RIGHT and
LEFT
Measure
Light intensity (lux)
Intensità luminosa (cd)
Operating height (center of
the beam-floor)
Protection degree of the
case:
19
damaged, contact the
Range of
Distance
measurement
0 – 40 cm
0 – 4 %
0 – 2.288°
10 m
0 – 100 cm
0 – 10 %
0 – 6.000°
0 - 240 25 m
0 – 150.000 1 m
0 - 150.000 25 m
from 240 to 1400 mm
IP40