Electrical Safety; Before Starting Up - Racing RAC1440ET Instrucciones Originales

Cultivadora eléctrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

stop immediately after switching off.
Use caution when cleaning or performing maintenance on the device. DANGER!
Watch your fingers! Wear gloves!
It is forbidden to move or modify any of the electrical and mechanical safety
devices.
The machine must be stopped when carrying out maintenance and cleaning
operations, when changing tools or when transported by means other than under
its own power. If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service agent.

Electrical safety

The mains voltage must correspond to the one marked on the technical data plate
(230V~50Hz). Do not use other sources of power.
The use of a safety circuit-breaker is recommended for the power supply line for
an intervention range of 10 to 30 rated mA. Consult a reliable electrician.
Never pass the device over the extension cable that the application is working, as
this could cut the cable. Mark sure you always know where the cable is.
Use the special cable holder for the connection of the extension cable.
Never use the device when it is raining. Try to prevent it from getting wet or being
exposed to humidity. Do not leave it outside overnight. Do not cut damp or wet
grass.
The power supply cable should be checked regularly and before using it each
time, make sure the cable is not damaged or old out. If the cable is not in good
condition, do not use the device; take it to an authorized service center instead.
Only use an extension cable that is suitable for outdoor work. Keep it away from
the cutting area, from damp, wet or oily surfaces or with sharp edges and away
from heat and fuels.
The mobile socket of the extension cable should be splash proof in compliance
with DIN 57282 and VDE 0282 regulations; the cross-section of the wire (max.
length 75 m) should be at least 1.5 mm

Before starting up

Intend use
This device is only intended as an electric tiller for aerating lawns and grassy areas
in private domestic and hobby gardens.
. Use H07RN-F harmonized cable.
2
22

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido