Racing RAC1440ET Instrucciones Originales página 27

Cleaning
Caution! Always clean the application after use. Failure to carry out proper cleaning
can result in damage to the application or cause it to malfunction.
Warning! Injury can occur during work on the tines. Wear protective gloves.
Whenever possible, clean the application straight after you have finished working on
the lawn.
Clean the underside of the housing around the tines and the protective shield and
fender with a scrubbing brush, and brush or soft cloth dampened with a mild soap
and water mixture. Never splash with water!
To remove soil and debris from the tines and transmission, use a stiff brush or a
dampened cloth.
Clean the ventilator, and remove any remaining grass or dirt.
Once cleaned, wipe the tine and shaft dry and apply a light coat of oil.
Tines Removal and Installation (Fig. 6)
Worn tine invites poor performance and overload of motor.
Check before each use the tines situation. Sharpen or replace the tines with new
one when necessary. It is recommended to do this by a specialist.
Caution! Disconnect the mains and wear protective gloves.
To remove the complete tines from the shaft (28):
Remove the bolts (36) and nuts (37) from the tines
Sequentially remove the outer set of tine (41) from the shaft and the tine (40) from
the inside.
Reverse above steps to install tines.
Checking lubricant (Fig. 5)
Lubricate the gear after first 20 operating hours, then every 40-50 hours operating
hours.
Drain screw plug (33) is located on the right side of transmission housing (35).
Lay the tiller on its left side and clean the transmission to prevent dirt and debris
before remove the drain screw.
Using a hex key 5mm to unscrew the plug and empty the oil from the
transmission housing.
Fill up by using a grease gun with a high-quality, automotive-grade grease until it
begins to seep out around the edge of the hole of the nozzle.
If necessary, disassemble tines.
Check the O-ring (A) for signs of wear and damage, and replace if necessary.
26