Lionelo Levi One Manual De Usuario página 11

Child safety seat with
backrest
Group I
The child from this group must be secured with child safety seat belts.
1.
Place the child safety seat on the car seat (fig. 6a).
2.
Pull the buckle of the car safety seat through the guide (O) to the back of the
seat, and then pull forward through the second guide (O) (see: fig. 6e, 6f).
3.
Make sure the shoulder belt does not go through the guide in the headrest
(C) (fig. 6c, 6d).
4.
The pelvis belt must go under the elbow rest (fig. 6b).
5.
Fasten car safety belts (fig. 6g).
6.
Press the child safety seat against the car seat firmly.
7.
The car seat belts which hold the child safety seat must be tight. Pull the
belts to tighten them up (figures 6h-6j).
8.
Place the child in the child safety seat (fig. 6k) and fasten 5-point safety
belts (fig. 6l).
Should you have any doubts about this point, contact the product manufacturer.
Group II – assembly with seat backrest
The child from this group must not be secured with the child safety seat belts.
The child must be secured with 3-point car safety belts.
1. Disassemble child safety seat belts (see: child safety seat belts – how to
disassemble belts).
2.
Place the child safety seat on the car seat. Push it against the seat backrest
as far as you can (fig. 14a).
3.
Put the child into the child safety seat (fig. 14b).
4.
Pull the car safety belt out. Carry:
a.
the shoulder belt through the guide in the headrest (fig. 14c).
b.
the pelvis belt under the elbow rest of the child safety seat (fig. 14d).
5.
Make sure the belts are not twisted (fig. 14e).
6.
Fasten the car safety belts (fig. 14f).
Child safety seat with
backrest or without it
(depending on child's
height)
‑ 11 ‑
Child safety seat
without backrest (base
only)
EN