Troubleshooting Guide - Bosch BHB120 Instrucciones De Funcionamiento

BM 2610031893 08-13_BM 2610031893 08-13 8/14/13 2:55 PM Page 6
When pressed, the USB port will determine if a
device is plugged in. If so, the USB port will
remain on as long as the device is attached
for a maximum of 2 hours. If after 60 seconds,
To reduce the risk of injury,
W RNING
always unplug the battery
holster/controller and remove the battery
pack before performing any maintenance.
Never disassemble the battery pack or
battery holster/controller. Contact a Bosch
service facility for all repairs.
keep the battery holster/controller,
battery and charger clean at all times.
Cause:
USB Port not producing power
the port does not detect a device initially
connected, it will deactivate, or go to sleep,
conserving battery power.
mAINTENANCE
Do
holster/controller, battery and charger
into water or other fluids.
Wipe off debris using a moist and soft
cloth. Do not use any cleaning agents or
solvents.
The battery is not serviceable and should
be repaired by an authorized service
center.
TROUBLE SHOOTING GUIDE
Corrective measure:
Check that battery pack is charged.
Plug in device and press the USB port "Wake-
W RNING
up" button for 3 seconds.
Check that your device does not require any more than 5 V
DC, 1 amp maximum output.
Unfortunately, not all devices can be tested for compatibility
and your device may not be compatible.
-6-
not immerse the battery