T-Fal CM362BMX Manual De Instrucciones página 11

• The screen will display the set time and the green light signal (l) will
turn on.
• In order to display the current time again, briefly press the
• At the set time, the red light signal will turn on and the coffee maker
will start.
WARNING: The set program is automatically deactivated at the end
of the coffee cycle; however, the set time is saved. Reactivate the set
program every day by pressing on the PROG button. In order to set a
different time, please refer to paragraph "Using the appliance in the
Program Mode".
It is possible at all times:
• Turn your coffee maker ON or OFF by pressing the
• Cancel the programming by pressing the PROG button for 2 seconds.
When you do so, the green light signal (l) will turn off.
• In order to reactivate the program on your coffee maker, press the
PROG button once.
• To change the set time, press the PROG button once more.
Manual functioning
Follow figures 1 to 8.
• Press the button. The red light signal will turn on and the coffee
maker will start functioning.
• Press the button once more to stop functioning.
PLEASE NOTE
• Whether you use your coffee maker manually or in the program mode, it
will turn off automatically about 30 minutes after the end of each cycle.
• During those 30 minutes, your coffee will be kept warm, at the right
temperature.
• When your coffee maker is switched on, it produces a single "beep" and
produces two "beeps" when it is switched off (depending on model).
button.
button.
EN
11