Metabo HPT WH 36DC Instrucciones De Seguridad Y Manual De Instrucciones página 17

Blinks ;
Output suspended due to failure
or malfunction. The problem
may be the battery so please
contact your dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
8. How to use the LED light
By pressing the light section switch on the switch
panel, the LED light mode changes as Table 6.
(Fig. 15)
To prevent the battery power consumption, turn off the
LED light frequently.
Switch panel
Light section
switch
Always-ON
mode
Always ON
(turn off after
State
10 minutes)
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
Fig. 15
Table 6
SW Always-OFF
interlocked mode
mode
Light only Always OFF
SW-ON
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 10 minutes.
9. Tightening mode selector function (Fig. 16)
CAUTION
● Do not subject the switch panel to shock or
damage.
● Select tightening mode while the trigger switch
is released. Failure to do so could result in
malfunction.
Tightening mode
selector switch
Switch panel
Tightening mode
indicator lamp
(1) Tightening mode selector switch
By using the Tightening mode selector switch, the
tightening torque can be adjusted according to the type
of work.
The Tightening mode switches between 5 diff erent modes
each time the Tightening mode selector switch is pressed.
Upon pulling the trigger switch in bolt single mode, the
driver will automatically stop after applying a number of
impacts.
Soft / power / bolt and self drilling screw mode will
commence impact upon pulling the trigger switch and will
continuously apply impact without auto-stopping.
Soft mode is a mode that does not infl ict damage on thin
nails or decorative materials.
Power mode can be used for normal work up to heavy load
work.
Bolt mode has a short pull margin for the trigger switch,
making the driver ideal for high-speed tightening work.
Bolt single mode controls the impact, allowing control of
the tightening force. Use this mode for delicate work such
as tightening bolts for racks, fences, furniture, etc.
Self drilling screw mode is ideal for tightening self drilling
screws by reducing the chances of overtightening that
could result in severing the screw head, breaking the
screw, or slippage.
English
Fig. 16
17