Important Safety Instructions
• The appliance must be stored in a room without continuously operating ignition sources (for example: open flames, an operating gas appliance
or an operating electric heater.)
• Do not dispose of any part of this unit in a fire.
• Be aware that refrigerants used may not contain an odor.
• Appliance should be installed, operated and stored in a room with a floor area larger than 13 m
• Servicing should be performed only as recommended by the manufacturer.
• The appliance shall be stored in a well-ventilated area where the room size corresponds to the room area as specified for operation.
• All working procedure that affects safety means should only be carried by competent persons.
• Please make sure the inlet and outlet ventilation are not blocked at all times.
• Do not operate this unit in an explosive or corrosive atmosphere.
• Clean air filter periodically for the most efficient cooling.
• When the unit is shut off, please wait at least 3.5 minutes before restarting this is to prevent the compressor from being damaged.
• This unit needs at least 7 Amps of electricity to have its compressor operational. Do not use any extension cord with this unit.
• When the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
hazard.
• This appliance is suitable for use in locations where children are likely to be present.
• This appliance can be used by children aged from 8 years and above and persons with lack of experience and knowledge if they have been
given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children must be supervised to ensure that they do not use the device as a toy.
• Cleaning and user maintenance should not be made by children without supervision.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended.
Impedance Declaration
We declare these models be connected only to a supply with the relevant system impedance no more than 0.219 ohm. Restrictions to
connection may be imposed by the supply authority on the use of equipment if the actual relevant system impedance at the interface point on
the user's premise exceeds 0.219 ohm. If necessary, consult your supply authority for system impedance information.
.
2
3