Tripp-Lite SRXCOOL12KEU Manual Del Propietário página 6

Installation
Connect the flexible cooling duct (shorter tube
2-3
the duct with the circular adapter opening, push the duct downward and turn the duct
clockwise to screw it into the adapter until it reaches the stop. Do not over-tighten or force
past the stop.
Place the other end of the cooling duct near the air intake of the target device or rack
2-4
enclosure, using the straightest, shortest path available. If you plan to cool a rack
enclosure, place the end of the cooling duct over a perforated area near the top of the
enclosure's front door (or near the top of the bank of equipment that requires cooling).
Cool air will sink and spread across the air intakes at the front of the rack enclosure.
Exhaust Duct Connection (Required)
3
Connect the flexible exhaust duct (longer tube
3-1
panel of the unit B . Align the duct with the circular vent opening, push the duct inward
and turn the duct clockwise until it contacts the stop.
Connect the other end of the exhaust duct
3-2
duct with the circular adapter opening, push the duct inward and turn the duct clockwise
until it screws into the adapter solidly.
If you plan to connect the exhaust duct to a drop ceiling, proceed to step
connect the exhaust duct to a window, proceed to step
A ) to the cooling duct adapter
A ) to the warm air exhaust vent on the rear
A to the exhaust duct adapter
4
5 .
6
B . Align
A
2-3
2-4
A
3-1
B . Align the
. If you plan to
B
3-2
B
B
A