Makita GTR01 Manual De Instrucciones página 19

Using the tool with the offset base
The offset base is used for trimming the edge of lami-
nate sheet or similar materials. The offset base is con-
venient for work in a tight area.
Fig.61
Using the trimmer base with the
offset base plate and grip
The offset base plate can also be used with a trimmer
base and a grip attachment (optional accessory) for
more stability.
1. Loosen the screws on the offset base plate, then
remove the offset base plate from the offset base.
Fig.62
► 1. Offset base plate 2. Trimmer base plate
1 2
2. Attach the offset base plate to the trimmer base by
tightening the screws.
3.
Attach the grip attachment and the bar type grip to
the offset base plate by tightening the screws.
1
2
Fig.63
► 1. Bar type grip 2. Grip attachment
The knob type grip removed from the plunge base can
be installed on the offset base instead of the bar type
grip.
1
2
Fig.64
► 1. Screw 2. Knob type grip
19 ENGLISH