Makita GTR01 Manual De Instrucciones página 8

NOTICE:
If the tool is operated continuously at
low speed for a long time, the motor will get over-
loaded, resulting in tool malfunction.
NOTICE:
The speed adjusting dial can be turned
only as far as 5 and back to 1. Do not force it past
5 or 1, or the speed adjusting function may no
longer work.
Electronic function
The tool is equipped with the electronic functions for
easy operation.
• Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
• Soft start
The soft-start function minimizes start-up shock,
and makes the tool start smoothly.
• Soft brake
The tool stops gently with the soft brake. The soft
brake prevents damage to the workpiece due
to recoil and allows you to start next operation
earlier.
If the tool consistently fails to stop the trimmer bit
after the switch is turned off, have the tool ser-
viced at a Makita service center.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing trimmer bit
NOTICE:
Do not tighten the collet nut without
installing a trimmer bit, or the collet cone may
break.
Insert the trimmer bit all the way into the collet cone.
Press the shaft lock and tighten the collet nut with the
wrench.
Fig.6
► 1. Shaft lock 2. Loosen 3. Tighten 4. Wrench
5. Collet nut
3
2
4
5
1
You can also tighten the collet nut securely with the two wrenches.
1
Fig.7
► 1. Wrench 2. Loosen 3. Tighten 4. Collet nut
To remove the trimmer bit, follow the installation procedure in reverse.
NOTE: The shaft lock may not return to the original position when
you tighten the collet nut in the installation of the trimmer bit. The
shaft lock returns to the original position when you start the tool.
1
Fig.8
► 1. Shaft lock
Changing the collet cone
CAUTION:
Use the correct size collet cone for
the trimmer bit which you intended to use.
CAUTION:
Do not tighten the collet nut without
installing a trimmer bit, or the collet cone may break.
1.
Loosen the collet nut and remove.
2.
Replace the installed collet cone with desired collet cone.
3. Reinstall collet nut.
Fig.9
► 1. Collet cone 2. Collet nut
8 ENGLISH
3
1
2
4
1
2