Makita GTR01 Manual De Instrucciones página 21

If the distance (A) between the side of the workpiece
and the cutting position is too wide for the parallel ruler,
or if the side of the workpiece is not straight, the parallel
ruler cannot be used.
In this case, firmly clamp a straight board to the work-
piece and use it as a guide against the plunge base.
Feed the tool in the direction of the arrow.
A
Fig.71
Changing knob type grip to bar type
grip
To install the bar type grip on the plunge base, loosen
the screw of the knob type grip, then remove the knob
type grip, and then install the bar type grip by tightening
it.
Fig.72
► 1. Knob type grip 2. Screw 3. Bar type grip
WIRELESS ACTIVATION
FUNCTION
What you can do with the wireless
activation function
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
Fig.73
To use the wireless activation function, prepare follow-
ing items:
•
•
The overview of the wireless activation function
setting is as follows. Refer to each section for detail
procedures.
1.
1 2
2.
3.
Installing the wireless unit
Optional accessory
CAUTION:
surface when installing the wireless unit.
NOTICE:
before installing the wireless unit. Dust or dirt
may cause malfunction if it comes into the slot of the
wireless unit.
3
NOTICE:
static, touch a static discharging material, such
as a metal part of the tool, before picking up the
wireless unit.
NOTICE:
always be sure that the wireless unit is inserted
in the correct direction and the lid is completely
closed.
21 ENGLISH
A wireless unit (optional accessory)
A vacuum cleaner which supports the wireless
activation function
Installing the wireless unit
Tool registration for the vacuum cleaner
Starting the wireless activation function
Place the tool on a flat and stable
Clean the dust and dirt on the tool
To prevent the malfunction caused by
When installing the wireless unit,