Wet Vacuuming - Truper ASP-5S Manual

Wet vacuuming

• Open the vacuum cleaner as shown on page 6 to install
the foam filter for wet vacuuming.
• Remove the blower (see next section) and turn the canister
lid upside down.
• Remove the cartridge filter and install the foam filter in the
filter cage (H) as shown in the picture. Then install the
motor cover in place.
• Do not vacuum or work near toxic,
WARNING
flammable or explosive materials as indicated in the safety
warnings on page 5.
CAUTION • Do not use the dry vacuum cloth filter
for vacuuming liquids.
• When vacuuming large quantities of
CAUTION
liquids, do not immerse the nozzle completely in the
liquid; leave a gap at the tip of the nozzle opening to allow
air flow. The machine is designed with a float valve that
stops the suction action when the container reaches
maximum capacity. You will notice an increase in motor
speed. When this happens, turn the machine off, unplug
the power cord from the outlet, open the vacuum and
empty the liquid from the canister into a receptacle or a
drain.
• At the end of the vacuuming job, empty the canister
before storing the vacuum cleaner.
Blowing
WARNING
• Read, understand and follow the
safety warnings on page 5.
• Move both levers ( I ) outward to release the blower
from the container lid.
• Attach the adapter to the blower port.
• Attach the blow nozzle to the adapter.
• Turn the blower on.
8
ENGLISH
Start Up
H
I
I