Battery And Charger; Charging Procedure - MIRKA ARG-B 200 Instrucciones De Montaje

Cordless
Vibration emission uncertainty K
Specifications subject to change without prior notice. Model range may vary between markets.
*
In order to reflect normal working conditions of the sander the operating conditions did deviate from the standard
method as follows: Grain size of the abrasive was 5 m. Feed force was 10 N.
*
The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation. Values measured in a particular work place may be higher than the declared
values. The actual exposure values and amount of risk or harm experienced by an individual are unique to each
situation and depend upon the surrounding environment, the way the individual operates the machinery, the par-
ticular material being worked, work station design and the user's exposure time and physical condition. Mirka Ltd
accepts no responsibility for the consequences of using declared values instead of actual exposure values for any
individual risk assessment.
Further occupational health and safety information can be obtained from the following websites:
https://osha.europa.eu/en (Europe) or http://www.osha.gov (USA)
Proper use of tool
This tool is designed for grinding all types of materials such as paints, metals, wood, stone, plastics, etc. Do not use this
tool for any other purpose than that specified without consulting the manufacturer or the manufacturer s authorized
supplier. Do not use accessories that have a working speed of less than the maximum rated speed of the tool's free speed.
Any maintenance or repair work requiring the motor housing to be opened may only be carried out by an authorized
service center.

Battery and charger

The battery pack is not fully charged out of the carton. First read the safety instructions and then charge your battery
according to the instructions.
For optimal charging capacity the battery should be charged at an ambient temperature between 18 °C (64 °F) and 24
°C (75 °F). To prevent damage to the battery pack, do not charge the battery pack where the air temperature is below
4 °C (32°F) or above 40 °C (104 °F).
To obtain the longest possible battery life, we suggest the following:
Store and charge your battery in a cool area. Temperatures above or below normal room temperature will shorten
battery life.
Never store the battery in a discharged condition. Recharge it immediately after it has been discharged.
All batteries gradually lose their charge. The higher the temperature, the quicker they lose their charge.
If you store your tool for long periods of time without use, recharge the battery every month. This practice will prolong
battery life.

Charging procedure

Connect the power cord to the charger, and then plug into an outlet before inserting battery pack. All three charging
lights will be on for two seconds and then turn off.
Insert the battery pack into the charger. The lights will start to flash within 30 seconds.
During the charging process, the charging lights will indicate the status as follows:
Three charging lights will flash in sequence during the charging process.
Fully charged, all three lights will remain on continuously.
The charging process will last approximately 50 minutes for BPA 10825 and 100 minutes for BPA 10850 battery pack.
NOTE! This charger can only charge Mirka 10.8 V battery packs.
NOTE! Charging times may be longer depending on the surrounding temperature and battery conditions.
LED indication of 10.8 V charger
ARG- B 200
* 2
1.5 m/s
en (original)
Mirka® ARG-B 200 Cordless grinder
81