Storage And Handling - MIRKA ARG-B 200 Instrucciones De Montaje

Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an app from which additional
tool functionality can be accessed. For more information on the app functionality and if it is available in your country, go
to www.mirka.com/mymirka
Activate Bluetooth on your Mirka
1. Connect the battery to the tool.
Press and hold the rpm+ button while activating the tool by pressing the switch trigger.
2.
Middle LED is flashing green, to indicate that Bluetooth is active and ready for connections.
3.
4. Middle LED is lit green when the tool is connected to another Bluetooth device.
Bluetooth is deactivated when the tool is deactivated/turned off.
5.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
®
The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Maintenance
Always remove the battery before maintenance!
Only use original Mirka spare parts!
Replacing accessory
Installing collet
The collet must be attached to the collet nut before installing the collet assembly to the tool. Be sure that the collet size
matches the size of the mandrel you will use, otherwise the collet may break.
1. To assemble, place collet on an even surface, and place the nut over the collet.
Press down on the nut to snap the nut and collet together.
2.
3. To disassemble, use a rod to push the collet out of the nut.
Installing accessory
Remove dust and debris from the collet body before inserting accessory.
1.
Insert the collet with the collet nut attached into the collet body. Thread the collet nut onto the spindle but do
2.
not tighten it yet.
Clean the accessory mandrel, then insert it a minimum of 20 mm and 50% of accessory shaft length.
3.
4. Hold the spindle shaft steady with a 14 mm open end wrench and securely tighten the collet nut with an 17 mm
open end wrench.
5. Reverse the procedure when removing the accessory.

Storage and handling

Storage in a dry place, protected from rain and frost. Keep free of pressure to avoid deformation.
®
ARG-B 200 as follows:
en (original)
Mirka® ARG-B 200 Cordless grinder
83