Intended Use; Items Supplied - Hilti NURON SL 6-22 Manual De Instrucciones

▶ If the battery is too hot to touch, it may be defective. Put the battery
in a place where it is clearly visible and where there is no risk of fire,
at an adequate distance from flammable materials. Allow the battery
to cool down. If it is still too hot to touch after an hour, the battery is
faulty. Consult Hilti Service or read the document entitled "Instructions
on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage
and use of lithium-ion batteries. → page 24
Read the instructions on safety and use of Hilti Li-ion batteries
that you can access by scanning the QR code at the end of these
operating instructions.
3 Description
3.1 Product overview
Lamp head
@
LEDs
;
Vertical pivot joint
=
Installation opening for acces-
%
sories
Battery
&
Mode switch (light intensity)
(

3.2 Intended use

The product described is a cordless floodlight. It is used for lighting up
jobsites.
The lamp head can be pivoted horizontally and vertically. Additionally, the
light can be set on a flat surface, suspended from various construction
materials by means of the integral hook, or mounted on a tripod with 5/8"
thread.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22
series. For optimum performance, Hilti recommends the batteries stated
in the table at the end of these operating instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in
the table at the end of these operating instructions.

3.3 Items supplied

Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
18 English
1
)
+
§
/
:
∙
$
Locking switch, vertical
Heat sink
Carrying handle
5/8" thread for tripod mount
Suspension/attachment hook
Battery release button
Battery status indicator
2265889
*2265889*