HomeMatic IP HmIP-WKP Manual De Instalacion Y Uso página 28

Operation
First set up your Homematic IP Access Point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the operating manu-
al of the Access Point.
To integrate the Homematic IP Keypad into your system and enable it to
communicate with other Homematic IP devices, you must first add the
device to your Homematic IP Access Point.
To add the Keypad, please proceed as follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Add device".
• Remove the Keypad (B) from the wall bracket (A), by inserting a
thin object into the hole on the bottom of the wall bracket (A)
and releasing the latch (M) (see figure 3).
Open the Keypad's rear battery compartment (J) by loosening
•
the screw on the battery compartment cover (see figure 4).
• Pull the insulating strip out of the battery compartment of the
Keypad (first start-up).
As soon as the insulating strip has been pulled out, the device sends
a tamper message, and the device LED (G) flashes red six times (see
„7.5 Error codes and flashing sequences" on page 33).
• The pairing mode is active for 3 minutes.
You can start the pairing mode manually for another 3 minutes by
briefly pressing the system button (H).
Close the battery compartment (J) and tighten the screw on the
•
battery compartment cover again.
• The device automatically appears in the Homematic IP app (see
figure 6).
• To confirm, enter the last four digits of the device number (SG-
28