Installation; Installing The Wall Bracket - HomeMatic IP HmIP-WKP Manual De Instalacion Y Uso

TIN) in the app or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
• Please wait until pairing is completed.
If pairing was successful, the device LED (G) lights up green. The
•
device is now ready for use (see figure 6).
If the device LED lights up red, please try again.
• In the app, give the device a name and allocate it to a room.
• Set up access using the free Homematic IP app.
• Only insert the Keypad into the wall bracket after installation.
5.2

Installation

The Keypad housing has a drainage hole (K). Open it with a sharp
tool if necessary.
Please read this entire section before starting the installation.
5.3

Installing the wall bracket

When selecting a mounting location and drilling in the vicinity of
switches or socket outlets, check for electrical wires and power
supply cables.
The mounting location should be protected from the weather and
not exposed to direct sunlight or other sources of heat radiation.
To install the wall bracket (A), proceed as follows:
• Choose a suitable site for installation.
Remove the keypad (B) from the wall bracket (A), by inserting a
•
thin object into the hole on the bottom of the wall bracket and
releasing the latch (M) (see figure 3).
Operation
29