HomeMatic IP HmIP-WKP Manual De Instalacion Y Uso página 34

Troubleshooting
1x long red flash
Short orange
flashing (every 10
s)
Short orange light-
ing (after green or
red confirmation)
1x orange and 1x
green flash (after
inserting batteries)
Long and short
orange flashing
(alternating)
6x short red flash-
ing of the device
LED (G)
34
PIN incorrect or not
authorised at the cur-
rent time
/
Entry temporarily or
permanently locked
/
Duty cycle
Pairing mode active
Battery empty
Test display
Software update
(OTAU)
Tamper message
Re-enter the PIN to check
its correctness or whether
you are authorised at the
current time
/
Temporary or permanent
lock after incorrect entry;
reset the permanent lock in
the app
/
Try again (see „7.4 Duty
cycle" on page 33)
Enter the last four numbers
of the device serial number
to confirm (see „5.1 Pairing"
on page 27).
Replace the batteries (see
„6 Changing the batteries"
on page 31)
You can continue once the
test display has stopped.
Wait until the update is
completed.
Insert the Keypad (B) into
the mounting plate (A) and
acknowledge the tamper
message in your app.