Functional Description - Milwaukee M12 3632-20 Manual Del Operador

Federal Communications Commission
WARNING
proved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or televi-
sion reception, which can be determined by turning
the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
SPECIFICATIONS
Cat. No. ..................................................... 3632-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
Laser............................................................Class 2
Max Power........................................... P
Frequency....................................................10 KHz
Pulse Duration Normal Mode ................. T
Pulse Duration Power Save.................... T
Wavelength.......................................... 510-530 nm
Beam Divergence ........................................... 3 rad
Storage Temp .................................... -4°F to 120°F
Working Range .................................................125'
Range with Detector .........................................165'
Accuracy ...............................................±1/8" @ 33'
Settle Time ......................................... < 3 Seconds
Tripod Mount ..................................1/4"-20, 5/8"-11
Ingress Protection............................................ IP54
Drop Rating .......................................................1 m
Leveling ............Auto ±°4 side to side, front to back
Recommended Ambient
Operating Temperature .................. 14°F to 104°F
Changes or modifications to
this unit not expressly ap-
≤ 8 mW
AVG
p
p

FUNCTIONAL DESCRIPTION

1. Laser apertures
2. On/Off dial
3. Pivot Bracket
4. Micro adjust
5. Fuel gauge
1
1
≤ 80 µs
7
≤ 50 µs
6
5
10
9
LASER
Brookfield, WI 53005 USA
CAT. NO. 3632-20
SER.
WARNING WARNING
To reduce the risk of injury, user
must read operator's manual. Use M12 batteries.
Pour minimiser les risques de
AVERTISSEMENT AVERTISSEMENT
blessures, l'utilisateur doit lire
le manual. Utiliser des piles M12 . ™
Para reducir
ADVERTENCIA ADVERTENCIA
el riesgo de
lesiones, el usuario debe leer el manual.
Utilice baterías de M12 .
™ Made in China
IEC 60825-1:2014-05 t
CONFORMANCE WITH IEC 60825-1 ED. 3., AS DESCRIBED IN LASER NOTICE NO. 56, DATED MAY 8, 2019. THIS DEVICE COMPLIES WITH PART 15
OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
3
SYMBOLOGY
Volts
Direct Current
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Magnets
Read operator's manual
6. Plane selector buttons
7. Power on indicator
8. Threaded inserts
9. Magnets
10. Nail/Screw hole
1
4
360°
3-PLANE
Milwaukee Tool
12 V
™
≤ 80 μs MAX OUTPUT P ≤ 8mW @ 510nm - 530nm COMPLIES WITH 21 CFR 1040.10 AND 1040.11 EXCEPT FOR
P AVG
2
3
8