Opening The Product; Installing The Product On The Wall - Mennekes AMTRON Compact 2.0 11 Manual De Instrucciones Y De Instalación

5.4

Opening the product

The tasks described in this section may only
be carried out by a qualified electrician.
Fig. 5: Open the product
When delivered, the upper section of the housing is
not attached with screws. The screws are included
in the delivery contents.
u Unscrew screws if necessary.
u Fold the top section of the housing downward.
5.5

Installing the product on the wall

ATTENTION
Material damage due to uneven surface
Installing on an uneven surface can cause the hous-
ing to go out of shape, so that the protection class
is no longer guaranteed. Consequential damage of
electronic components can occur.
u Only install the product on an even surface.
u If necessary, level out uneven surfaces with
suitable measures.
MENNEKES recommends installing at an er-
gonomically sensible height depending on
the height of the body.
14
The fastening materials provided (screws
and dowels) are only suitable for installation
on concrete, brick or wooden walls.
ATTENTION
Material damage due to drilling dust
Consequential damage of electronic components
can occur if drilling dust gets into the product.
u Make sure that drilling dust does not get into
the product.
u Do not use the product as a drilling template
and do not drill through the product.
u Create the drill holes using the drilling template
(included in the delivery contents) or first mark
the drill holes using the illustration "Drilling di-
mensions [mm]" and then drill them. The dia-
meter of the holes depends on the chosen
mounting hardware.
Fig. 6: Drilling dimensions [mm]
u Using a suitable tool, break out the required
cable entry point at the predetermined location.