Maintenance And Care - Kärcher KM 70/30 C Bp Manual De Instrucciones

Note
To achieve an optimum cleaning result, the
driving speed should be adjusted to take
specific situations into account.
Note
During operation, the waste container
should be emptied at regular intervals.
Note
Also lower side brush when cleaning along
edges.
Tilt the side brushed upward or down-
ward depending on the task.
Note
The dust blown up by the side brushes is
not sucked in. Place the side brushes at the
edge only while sweeping.
Set the programme switch to sweep or
sweep suction.
Dry floor Sweep
Wet floor Sweep
Move the appliance over the surface to
be swept.
Adjust the brush contact pressure
Lift, adjust and lower the lever for the
contact pressure of the sweeping roller.
+ Increase contact pressure.
– Reduce contact pressure.
Adjust the pressure by turning the turn-
ing handle for the contact pressure of
the side brushes.
+ Increase contact pressure.
– Reduce contact pressure.
Figure 5, see cover page
Note
A very high contact pressure means in-
creased power consumption and hence
lesser usage time.
Collect dirt
Figure 6, see cover page
Slightly press the pushing handle
downward so that the appliance lifts up
slightly towards the front.
Move the appliance with the raised up-
per part over the dirt.
Now lower the appliance again.
Battery display
The battery display shows the charging sta-
tus of the battery during operations:
full
30% capacity remaining
10% capacity remaining
Protection against total
discharge; the appliance
is switched off
Emptying waste container
Warning
Risk of injury on account of rotating roller
brush.
Before removing the waste container
please turn the programme selection to
"OFF" and wait until the roller brush comes
to a halt.
Note
Dust progress. As far as possible, shake off
the filter and empty the waste container in
open places.
Turn the program selection switch to
"OFF".
Sweep
Only Adv. model: Pull the handle of the filter
suction
shake-off many times and releaes it.
Sweep
Only Adv. model: Tilt the dust suction
upward.
Pull the waste container upward at the
handle and remove it from the appliance.
Figure 7, see cover page
Dispose off the waste according to local
regulations.
Turn the program selection switch to
"OFF".
Lift the appliance at the carrying han-
dles when you want to transport it.
Secure the wheels of the machine with
wheel chocks.
Secure the machine with tensioning
straps or cables.
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Park the sweeper on an even surface.
Lock the sweeper to ensure that it does
not roll off.
Clean the inside and outside of the
sweeper.
Warning
Danger of damage to the machine because
of water penetrating into the machine! The
machine should not be sprayed using a
high pressure water jet.
Park the machine in a safe and dry
place.
Disconnect battery.
Charge battery and recharge it approx.
every 2 months.
glows green
glows yellow
blinks red
glows red
Transport
Shutdown
3
-
EN
Transport
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Storage
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
Risk of injury. Before performing any tasks
at the machine, first turn the programme
selection switch to "OFF"and clamp the ca-
ble at the minus pole of the battery.
Cleaning the inside of the machine
Warning
Risk of injury! Wear dust mask and protec-
tive goggles.
Clean machine with a cloth.
Blow through machine with compressed
air.
External cleaning of the appliance
Clean the machine with a damp cloth
which has been soaked in mild detergent.
Note
Do not use aggressive cleaning agents.
Maintenance intervals
Daily maintenance:
Check the sweeping roller and the side
brush for wear and wrapped belts.
Check function of all operator control el-
ements.
Weekly maintenance:
Clean both the foam filters under flow-
ing water.
Only Adv. model: Check flat-fold filter.
Check moving parts for freedom of
movement.
Check the sealing strips in the sweep-
ing area for wear.
Half-yearly maintenance:
Check tension, wear and tear and func-
tioning of the drive belts.
Maintenance following wear:
Replace sealing strips.
Replace roller brush.
Replace side brush.
For description, see section on Mainte-
nance work.
Note
Where maintenance is carried out by the
customer, all service and maintenance
work must be undertaken by a qualified
specialist. If required, a specialised Archer
dealer may be contacted at any time.
11