Lionelo Nico Manual Del Usuario página 10

provides a better chance of their survival. Make sure that all the users can
properly install and use the safety seat.
•
It is recommended to install the safety seat on a backseat of a car.
•
The child restraint straps must be adapted to the child's physique. They cannot be
twisted. It is important that the. lap belts run low so that the pelvis is held firmly.
•
Keep this manual for future reference.
Note:
Do not install the safety seat on a car seat with an active airbag. Otherwise it may cause
permanent damage to health or death.
Rigid items and plastic parts of a child restraint must be located and installed in such a way
so that, under normal operating conditions of the vehicle, they cannot be trapped or jammed
by a sliding seat, a door, etc.
3. Description fig. 4
a.
Harness
b.
Buckle
c.
Harness adjustment button
(under the fabric)
d.
Headrest
e.
Harness
3.1 Attaching the seat to the backrest (fig. 7):
1.
Place the seat and the backrest on a flat surface.
2.
Connect the backrest hooks with the seat mounts. Push the hooks so that
they lock firmly on the mounts.
3.
Lift the backrest until the angle between it and the seat is 90°.
To disconnect the backrest from the seat, please follow the above steps in reverse order.
4. Usage method for group I
The 5-point safety harness is dedicated strictly for children from the first mass
group that is those weighing from 9 to 18kg (aged from about 9 months to 4 years).
4.1 Shoulder straps height adjustment (group I)
Make sure the position of the shoulder straps is suitable for your child. Straps should
be passed through the slots at the level of child's shoulders or slightly above (fig. 8).
A.
INCORRECT - too low
B.
INCORRECT - too high
EN
f.
Backrest
g.
Seat
h.
Harness adjustment strap
fig. 5 Seat belts
fig. 6 Strap inlets
C.
Correct
‑ 10 ‑