Lionelo Nico Manual Del Usuario página 11

If the position of the straps is not correct, adjust it by following the steps below:
Step 1: Loosen the straps (see section 4.3). Turn the seat so as to get access to
the rear part (fig. 9).
Step 2: Pull the both straps out of the strap connector (fig. 10).
Step 3: Turn the seat so that you can see the front and carefully pull the two straps
(and their pads) towards you so as to remove them completely from the slots in the
backrest of the seat (fig. 11).
Step 4: Then carry the straps back through the slots in the backrest located at the level
appropriate for your child (fig. 12).
Step 5: Turn the seat again, so that you can see its rear, and attach the two straps to
the strap connector.
Make sure the height of the shoulder straps is correct, they are not twisted and that
they are properly locked in metal mounts (fig. 13).
4.2 Installation of the safety seat in a car (group I)
Step 1: In a car equipped with 3-point seat belts, place the safety seat on the car seat
in a way so that the flat surface of the backrest of the safety seat rest tightly against
the vehicle seat (fig. 14).
Step 2: Carry the car seat belt connector (along with the entire belt) through the nearest
guide (from the front to the back), then behind the backrest of the safety seat and
through another guide (from the back to the front) located on the side of the car seat
belt buckle. Insert the car seat belt connector to the car seat belt buckle. You should
hear „the click sound" indicating that the belt has been properly fastened (fig. 15).
Step 3: Make sure that the lap belt is carried under the arm rest.
Note: Make sure that the belts are not twisted (fig. 16a).
Step 4: Use your knee to push the safety seat tightly to the seat of the car and tighten
the shoulder belt in a direction shown in the Figure 16b. Make sure the belt is not loose.
The shoulder belt should be tightened as tightly as possible (fig. 16c).
The Figure 16d shows the correct position of the seat belt buckle in relation to the
safety seat. In case of any questions concerning the installation method, please contact
the seat manufacturer.
To remove the safety seat from the car, please follow the above steps in reverse order.
Make sure the belts are tight and not twisted, and that the seat pad in no way blocks
their proper arrangement.
The installation method for children from group I mustn't involve the headrest
guides. They are used in the installation method for children from groups II and III.
‑ 11 ‑ EN