Kohler Kumin K-104K36-SANA-CP Instrucciones De Instalación página 5

2. Install the Control Box
NOTE: Verify that the hose will reach the supply stop by attaching the flex hose to
the control box inlet.
NOTE: Refer to the specification sheet to determine the control box installation
location.
Verify that the sensor cable is below the countertop.
Unthread the control box screws to remove the cover.
Drill 1/8" (3 mm) pilot holes.
Use the standard wall anchors (provided) depending on your wall material.
Attach the control box to the wall with the arrow pointing upward. Secure with
the two screws (provided).
Kohler Co.
Inlet
5
1357694-2-B