Faucet Installation - Kohler Kumin K-104K36-SANA-CP Instrucciones De Instalación

1. Faucet Installation

NOTE: Before drilling the mounting hole, use the following dimensions for proper
placement:
Dimensional Requirements
A 1-1/4" (32 mm) minimum to 1-1/2" (38 mm) maximum diameter mounting hole is
required.
A minimum distance of 1-3/4" (44 mm) is required between the back of the spout and
the wall to allow access to the screw.
A 1-1/8" (29 mm) maximum distance is required between the sink bowl edge and the
base of the spout.
Install the Faucet
Determine the mounting-hole location.
Drill a hole through the mounting surface according to the surface manufacturer's
instructions.
Insert the spout with water inlet hose and stud through the mounting hole.
From under the sink, install the o-ring, rubber washer, and bracket onto the stud.
Thread the nut onto the stud until the faucet is secure.
1357694-2-B
Spout
O-Ring
Rubber Washer
Flexible Hoses
4
Sensor
Stud
Bracket
Nut
Kohler Co.