Craftsman CMCE030 Manual De Instrucciones página 15

Accessories

WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be used
with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN call 1‑888‑331‑4569.
Accessories Chart
1/4" Drum Sander Mandrel
1/2" Drum Sander Mandrel
Wrench
5/8" x 3/8" Orange 120‑Grit
Aluminum Oxide Grinding
Wheel Bits
3/8" x 1/2" Orange 120‑Grit
Aluminum Oxide Grinding
Wheel Bits
1‑1/4" Fiberglass Cut‑off
Wheel used with mandrel
1/4" Screw Mandrel
1/4" x 1/2" Sanding Drums,
60 Grit, 120 Grit, ard 240 Grit
used with mandrel
1/2" x 1/2" Sanding Drums,
60 Grit,120 Grit, and 240 Grit
used with mandrel
Felt Polishing Wheels used
with mandrel
Potsling Compound Vial
1/8" High Speed Steel
Drill Bit
Accessories Chart
Attaching sanding
drums
Changing accessories
Repairs
Grinding nails/screws
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.

Cutting bolts, screws,
nails, and thin wood
Register Online
Attaching polishing
Thank you for your purchase. Register your product now for:
wheels
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
Sanding white pine
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification
is required under the Federal Consumer Safety Act.
Polishing and buffing
• Register online at www.craftsman.com/registration
metals, stone, glass
and ceramics
Polishing and
brightening metals
and plastics.
Drilling
Wire Brush Wheel
Cut‑off Wheel Mandrel,
1/8" shank
1/32" Engraving Bit
Hgh‑speed Cutter
Conical Grinding Stone
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a CRAFTSMAN factory service center
or a CRAFTSMAN authorized service center. Always use
identical replacement parts.
English
Brushing metal
Attaching cut‑off
discs, cut‑off wheels,
grinding wheels, and
emery wheel
Engraving metals
Shaping curved
surfaces
Grinding metal edges
13