Adjusting The Shoe - Makita GRJ02 Manual De Instrucciones

NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: When the tool is overheated, the lamp blinks
for one minute. In this case, cool down the tool before
another operation.

Adjusting the shoe

WARNING:
Always remove the battery car-
tridge and the recipro saw blade when removing
or adjusting the shoe.
CAUTION:
Always install the shoe and make
sure that the shoe touches the workpiece before
operating the tool.
CAUTION:
Always make sure that the shoe
is adjusted in proper position so that the reci-
pro saw blade does not touch the tool during
operation.
Fig.7
When the recipro saw blade loses its cutting efficiency
in one place along its cutting edge, reposition the shoe
to utilize a sharp, unused portion of its cutting edge.
This will help to lengthen the life of the recipro saw
blade.
The position of the shoe can be adjusted in 6 levels.
To reposition the shoe, open the shoe adjusting lever
and select the suitable position, then close the shoe
adjusting lever.
1
2
Fig.8
► 1. Shoe 2. Shoe adjusting lever
NOTE: The shoe cannot be adjusted without opening
the shoe adjusting lever fully.
Cleaning inside of the shoe
You can remove the shoe and clean dust or chip inside
of the tool.
1. Pull the shoe adjusting lever fully.
2.
Pull out the shoe while pushing the button.
1
Fig.9
► 1. Shoe 2. Shoe adjusting lever 3. Button
3. Remove dust or chip inside the tool.
4. Install the shoe while pushing the button.
5. To reposition the shoe, open the shoe adjusting
lever fully and insert the shoe into the suitable position,
then close the shoe adjusting lever.
Hook
CAUTION:
When hanging the tool, set the
lock-off button in
trigger. (See the section for switch action.)
CAUTION:
Never hang the tool at high or
potentially unstable location.
CAUTION:
Use the hanging/mounting parts for
their intended purposes only. Using for unintended
purpose may cause accident or personal injury.
CAUTION:
Do not hook the tool on your belt
or other accessories. The recipro saw blade may
contact your body and cause personal injury.
Fig.10
► 1. Hook
The hook is convenient for hanging the tool temporarily.
To use the hook, simply lift up hook until it snaps into
the open position.
When not in use, always lower hook until it snaps into
the closed position.
8 ENGLISH
3
2
position to lock the switch
1